Language: 영어 중국어 간체 독어 힌두어 베트남어 크로아시아어 체코슬로바키아어 덴마크어 화란어 불어 일어 핀란드어 그리스어 아이슬랜드어 인도네시아어 네팔어 폴란드어 브라질 포르투갈어 포르투갈 포르투갈어 케추아어 로마니아어 소말리아어 스페인어 스웨덴어 타밀어 터어키어 우크라이나어 우르두어 우즈베크어 줄루어
Banana Switchblade 3D Model
3D Model Description:
I present the latest innovation in banana defense technology: the banana switchblade. This single action karambit style switchblade has no practical use as it is just a dull toy but it is a lot of fun to play with. Single action means the blade ejects when the switch is pushed forward. When the switch is pushed back it unlocks the blade but does not retract it. The blade must be manually reset to eject out again.
This design does not require any metal hardware like springs or screws and prints with minimal supports. Instead of springs to lock the blade this design uses printed latches to lock the blade in place. These latches pivot down when not in use meaning they are not under continuous tension. This is important because it allows the design to be made with PLA which permanently deforms under a continuous load. Instead of using screws the parts are pinned in place by 1.75mm filament.
Printing
I suggest printing each part in the orientation show in the sliced parts picture. I also suggest printing the tall parts with a brim. The supports are shown in green.
Rubber bands
All the parts are printed except for the rubber bands. The number of rubber bands needed depends on the type of rubber bands used.
