Language: 英语 德语 印地语 越南语 克罗地亚语 捷克语 丹麦语 荷兰语 法语 日语 韩语 芬兰语 希腊语 冰岛语 印度尼西亚语 尼泊尔语 波兰语 葡萄牙语（巴西） 葡萄牙语（葡萄牙） 盖丘亚语 罗马尼亚语 索马里语 西班牙语 瑞典语 泰米尔语 土耳其语 乌克兰语 乌尔都语 乌兹别克语 祖鲁语
Neon Benchy 3D Model
Neon Benchy 3D Model Description:
June’s Endless PLA subscription is out now! Since 4 of the 6 filaments are transparent we have decided to make some light inspired designs!
3D Model Settings:
-0.2mm layer height
-15-20% infill
-No supports necessary
– Battery
– Wire
Print all parts (reference the IG reel for assembly)
-Cut EL wire tube to 30in ( 762mm) length
-Insert the battery pack into the bottom case
-Be sure to have the USB-C port face the hole on the case
-Be sure to have it lay with the button facing up
-Insert the rail through the top case hole
-Insert all of the tube through the top case hole
-Start with the end of the EL wire, start laying the EL wire into the rail at the “port hole” on the neon benchy
-Cap the rail with the rail cap
-Lay extra wire into the bottom case
-Snap the top case onto the bottom case
-Snap the neon rail assembly through the bottom case
-Plug a USB-C charger into the case and use the power button to turn on and off
